Cause: SM5 Fell Asleep While Lid Was
Open
The SM5 uses a magnetic sensor to detect when the
lid goes from open to closed or from closed to open. The action of opening the
lid normally signals the recorder to wake up and turn on its display.
If the SM5 is left open for an hour and begins a
schedule sleep period, the recorder will not wake up to button presses until
either the scheduled sleep period ends or until it detects the lid being opened
from a closed state.
Solution: Close and Reopen the Lid
Procedure
-
Close the front lid of the enclosure so that it contacts the rear
compartment.
It is not necessary to latch the enclosure shut.
-
Reopen the front lid.
The display should turn on and show the main status
screen.
-
Update the
recorder's firmware.
Old firmware versions allowed the SM5 to
fall asleep more quickly while the lid is open.
Solution: Turn the Power Off and On
Procedure
-
Turn the power switch off, then on again.
-
Update the
recorder's firmware.
Old firmware versions allowed the SM5 to
fall asleep more quickly while the lid is open.
Cause: Clock Battery Set-Up Not Complete
During manufacturing, the SM5 in normally powered
off and on again, which prompts the recorder to establish a connection to the
clock backup battery. If this step was missed, the SM5 will not power on normally.
Solution
Procedure
-
Set the SM5's power switch to Off.
-
Remove all batteries and any external power source.
-
Set the power switch to On.
-
Reinsert the batteries, or reconnect an external power source.
The SM5's display should wake up
and display the status screen.
-
Press Enter
, then
select .
-
Turn the power switch Off, then wait for the
Shutting down message to disappear from
the screen.
The SM5 will establish a
connection with the clock battery. You should not need to perform these
steps again in the future, even if you replace the clock
battery.
-
Turn the power switch On.
The SM5 should power
on.