In the simplest configuration, the SMART Controller can connect to two microphones via Ethernet cables with Power over Ethernet (PoE) support, up to 100 meters in length for a direct connection.
Each SMART microphone ships with two accessories that should be used as part of each deployment:
- A kit for securing an Ethernet cable to the microphone and weatherproofing the connection
- An Ethernet Surge Suppressor for diverting electrical surges away from the SMART Controller
To connect more microphones or to connect over distances greater than 100 meters, PoE switches or extenders can be used between the SMART controller and each microphone.
Two Microphones Connected to One SMART Controller via Ethernet
Two microphones can be connected via ethernet directly to the SMART Controller's PoE+ ports, which provide PoE to the microphones. An in-line, grounded surge suppressor is installed between the SMART Controller and each microphone to protect the SMART Controller. The total distance between the SMART Controller and each microphone can extend up to 100 meters without signal degradation.
Three Microphones Connected to One SMART Controller via Ethernet Switch
More than two microphones can be connected to a SMART Controller if their signals are combined using a powered, PoE-compatible Ethernet switch. Because the switch is powered and actively repeats outgoing signals, an additional 100-meter span of cable can be added to the total distance.
Typically, microphones are the component most exposed to electrical discharges. Therefore, surge suppressors are installed in between the switch and each microphone to protect all downstream components.
Microphone Connected to SMART Controller via Long-Distance Fiber Optic
Between the SMART Controller and the microphone, the signal is converted from Ethernet to fiber optic and back. To power the microphone, the signal converter on the microphone's end of the fiber optic run must be powered and able to provide PoE, or PoE must be injected through some other means.